Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Winston-Salem
If your chimney is pulling away from the house, the crown is crumbling, or a flue has been quietly leaking creosote into the brick for years, we can help. We repair chimneys across Winston-Salem, from the old masonry stacks in West End and Old Salem to the factory-built fireplaces in the mid-century ranches out toward the county line. We know this housing stock because we work on it constantly. Call (866) 343-2983 to book a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm.

Why Winston-Salem Homeowners Call Jasper Chimney Sweep for Chimney Repair
We treat a chimney as a system, not just a dirty flue. On a house with two fireplaces, a gas insert and a furnace flue, that means checking every flue and every connection, not only the one you burn in. Our technicians have up to 9 years of experience, and they work the whole loop: inspection, sweeping and repair under one company, so nothing slips between contractors who never spoke to each other.
Winston-Salem has a high concentration of pre-1950 homes with original masonry fireplaces, and many of them still have clay tile flues with no liner. That reality shapes how we work here. We also carry professional-grade materials, including HeatShield ceramic sealant and DuraFlex flexible liner systems, the same brands certified chimney technicians specify. You get a written picture of your chimney’s condition before any work begins, backed by a written estimate that sets the final price.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Chimney Masonry Repair in Winston-Salem
Chimney Masonry Repair in Winston-Salem usually starts with the same thing: mortar that has softened and brick faces that have begun to flake. A typical masonry repair in Winston-Salem runs $400 to $1,200 for repointing and spot brick work, while a partial rebuild of the section above the roofline runs $1,800 to $4,500. The written estimate sets the final price once we know how far the damage goes. Spalling brick and open joints let water in, and once water is in the masonry, freeze cycles and damp springs work the damage deeper.
Mortar Repointing and Tuckpointing
Our repointing and tuckpointing work replaces failed mortar joints with a mix matched to the older brick in these homes, so the repair doesn’t stand out or trap moisture. We cut out the loose mortar to a proper depth rather than smearing a skin over the joint. Tuckpointing follows the same process on the joints that are still sound but worn.
Waterproofing and Flashing
Chimney Waterproofing runs $200 to $600 for a typical Winston-Salem stack and is what keeps damp spring air from soaking into brick that has just been repaired. Flashing Repair, usually $250 to $700, seals the joint where the chimney meets the roof, which is where many leaks begin. These are not a subscription service; they are one-time repairs, and the estimate tells you whether they can safely wait a season.
Chimney Cap Installation in Winston-Salem
Chimney Cap Installation in Winston-Salem protects a flue from rain, animals and the heavy leaf fall that clogs spark arrestors each autumn. A standard cap runs $250 to $650 installed. A custom cap, which some neighborhoods require, runs $450 to $1,200 depending on the flue count and fabrication. When water is entering an open flue, a proper-fitting cap is often the cheapest fix on the whole system.
Caps for Multiple Flues
Houses with more than one fireplace usually need a cap that covers all the flues under one housing, rather than one small cap per opening. We fit Gelco and Famco caps and dampers built for longevity. One correctly sized unit protects the whole top of the chimney.
Why Historic Districts Change the Job
In West End and Ardmore, historic district design guidelines can restrict exterior chimney caps or chase covers. So we often use custom-fabricated interior-fit caps that sit inside the flue instead of changing the chimney’s exterior profile. We also document conditions for preservation review, so a homeowner has a record when the question comes up.
This is the part a generic chimney page misses. In Winston-Salem’s historic districts, the fix for a leaf-clogged, open spark arrestor often has to be designed around the rules rather than simply bolted on top of the stack.

Trusted Brands We Service in Winston-Salem
We work with professional-grade chimney industry brands, including HeatShield ceramic sealant for liner repair, DuraFlex flexible liners for relining jobs, and Gelco and Famco for caps and dampers. We can also work with Olympia Chimney and Copperfield products as the job calls for it. These are the materials certified technicians rely on nationwide, not big-box substitutes that need re-servicing in a couple of years. If you already have a brand-name liner, cap or damper, we can inspect and service it as part of the same visit, and the estimate covers the parts that may be needed. Because our scope stays inside chimney work, we don’t hand off the hard parts.
Common Chimney Repair Problems We See in Winston-Salem Homes
- Offset clay tile joints in 1920s flues. In many of the Craftsman and Tudor Revival homes around town, the original tile flue has offset joints and no liner. Unsealed, those joints let creosote and moisture migrate into the masonry and cause spalling that weakens the chimney from the inside.
- Historic district rules that block standard exterior caps. When guidelines prevent an outside cap or chase cover, flues are sometimes left open to leaf-clogged spark arrestors and animal entry. That makes draft worse and lets moisture in.
- Acidic creosote in unused summer chimneys. In a chimney that sits idle through the season, first-degree creosote can turn acidic in Winston-Salem’s damp springs and eat mortar joints. The gaps that result are hidden until a Level 2 inspection finds them.
- Factory-built fireboxes and crowns in mid-century ranches. The repair on these houses tends to focus on the firebox, damper and chimney crown, where rusted or cracked components let in damp air. Left alone, that moisture accelerates creosote degradation.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Repair in Winston-Salem, NC
Chimney repair in Winston-Salem isn’t a single price, so here are the ranges we use. Mortar repointing and spalling brick repair run $400 to $1,200. A partial chimney rebuild runs $1,800 to $4,500. Chimney cap installation runs $250 to $650, or $450 to $1,200 for a custom interior-fit cap. Waterproofing runs $200 to $600, and flashing repair $250 to $700. Relining, when a Level 2 inspection shows the flue needs it, is quoted separately based on flue length and liner type. The estimate is free, the price is set per job by the written estimate, and nothing is recommended without camera evidence you can see for yourself. Call (866) 343-2983 for an exact quote.
We Also Serve Cities Near Winston-Salem
We work throughout the Winston-Salem area, including Midway, Clemmons, Lewisville and Welcome. If you’re just outside the city, the same inspection, sweeping and repair service applies. You can see our full chimney repair service here, or read more about Winston-Salem and the neighborhoods we cover. Call to book and we’ll confirm the details for your address.
Serving Winston-Salem, NC – Our Local Coverage Area
We serve Winston-Salem and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Repair in Winston-Salem
Yes. HeatShield ceramic sealant and stainless liners are designed to fit inside the existing flue without altering the exterior. In many of these homes, a repair begins with a Level 2 inspection that reveals the gaps or spalling mortar, and the fix is an interior reline followed by a custom interior-fit cap when district rules restrict outside work. Call (866) 343-2983 for an exact quote – estimates are free.
Once a year for the whole system, even if you only burn in one fireplace. A house with several flues and a gas insert has more appliances to check, and the inspection covers every one, not just the one you use. That annual check is what catches hidden gaps before they become a rebuild. Call (866) 343-2983 to book a sweep and inspection.
First-degree creosote is light, flaky soot that a standard sweep removes; glazed, tar-like creosote has baked onto the flue and won’t come off with a brush. Glaze needs a specialized removal process, and in Winston-Salem’s damp springs, first-degree creosote in an unused chimney can turn acidic and start eating mortar. An inspection tells you which kind you have. Call (866) 343-2983 for a free estimate.
Because historic district design guidelines in places like West End and Ardmore can restrict exterior caps or chase covers that change the chimney’s profile. A custom interior-fit cap solves the problem by sealing the flue from inside without altering the outside of the stack. That keeps water and animals out while staying within the rules. Call (866) 343-2983 to discuss your address.
The firebox, damper and chimney crown are the usual trouble spots. Rusted or cracked components let in damp spring air, which then speeds up creosote degradation and mortar wear. Have the system inspected before you start burning again so small fixes stay small. Call (866) 343-2983 for an exact quote – estimates are free.
Book Your Chimney Repair in Winston-Salem
Whether your chimney needs repointing, a new cap, flashing repair or a full inspection to find out what it really needs, we’ll give you a written picture of the condition and a clear estimate. Call (866) 343-2983. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free, and the price is set per job by the written estimate.
Written by the team at Jasper Chimney Sweep.